![]() Possibly related to the above.ģ) The speed and feed overrides show as 25% even though the printer is 100%. I suspect this is just due to the time out being too short, and the slower Raspberry Pi.Ģ) Often I need to refresh the gcode print page for the new items to show up. Let me know if there is somewhere else you would like me to post these.ġ) When the uploaded gcode is processing, I will briefly get a message that communication with the server is lost. Okay I've done a few prints and things are working very well. Repetier-Server - the solution to control your printer from everywhere. Repetier-Software - the home of Repetier-Host (Windows, Linux and Mac OS X) and Repetier-Firmware. ![]() This then can also be used to create a special printer display. Then everyone should be able to integrate it and also do more like starting print etc. I think after releasing 0.50.3 I will start to document that and put documentation on under the documents page. Scripting is possible, at least when I have documented the around 60 functions that can remotely be used. Will test this some more to see why it sometimes fails on slower systems. On my beagle it sometimes looks like it uploads and then nothing happens. Local uploading on the mac always worked. So I need to find out the condition when this happens. Strangely enough after some failures I did something and it worked as expected. Yesterday I also run into the step 2 problem. So to make sure it really exists I have now added a mkdir for the next update. Normally adduser should have created it as home directory.
0 Comments
Leave a Reply. |